IOS Vendor ID payload (version: 1.0.0, capabilities: 20000001) With payloads : HDR + KE (4) + NONCE (10) + VENDOR (13) + VENDOR (13) + VENDOR With payloads : HDR + SA (1) + VENDOR (13) + VENDOR (13) + NONE (0) total length # 1 acceptable Matches global IKE entry # 2 Tion capability flags: Main Mode: True Aggressive Mode: True Message (msgid=0) with payloads : HDR + SA (1) + VENDOR (13) + VENDOR (13) + VEN If you run the "debug crypto isakmp 127" on the ASA, you will notice that the tunnel-group on which the connection lands is decided only after the 3rd exchange, that is, until then the ASA does not know what "tunnel group" this particular connection should land on and hence does not know if it's a L2L tunnel or a RA VPN tunnel.ĪSA5505(config)# Jan 19 13:39:49 : IP = 192.168.1.1, IKE_DECODE RECEIVED
#Check point vpn remove users windows 7
Perhaps this worked years ago when Windows 7 was a little bit younger,īut it does NOT work today.This is expected behavior on the ASA. Windows 7 appears to treat the RDP connection (while someone else is logged on) just like a regular "switch user" - these both drop the VPN connection.Ī fair number of articles say the VPN connection needs to have its properties configured to "Allow other people to use this connection" so that the connection will not drop. On, but during the process of "switch user" the VPN connection will drop. If we RDP to a system that is logged onto VPN we can get logged We use Remote Assistance most of the time to support off-site systems and it works forĮverything except uninstalling since a UAC prompt will pause the RA session per Microsoft as expected behavior at. We need a way to be able to "switch user" on remote PCs connected to VPN for those rare times we need to logon with admin rights to uninstall software.